EMP OP40 Electric Oil Pump
With a flow capacity up to 4 gal/min and discharge pressures up to 100 psi, the EMP OP40 Electric Oil Pump can handle a variety of fluid transfer applications including those for use with motor oil, hydraulic fluid, transmission fluids and gear lubes.
Rated Voltage
14-28 VDC
Size
7.0″ x 5.5″ x 5.5″
Weight
9.9 lbs (4.49 kg)
Flow Capacity
Up to 4.0 gal/min
Optimising systems
and applications as standard
The EMP OP40 Electric Oil Pump is a high performing and reliable cooling component with a large operating range and efficiencies making it suitable for a wide range of vehicles and applications.
High Power Density
The EMP OP40 offers best in class performance with flow capacity up to 4 gpm and discharge pressure up to 100 psi. Efficient mechanical design along with proprietary software allows sub-zero cold start capability.
Self Priming
EMP pumps are all 100% flow tested and incorporate internal geometry features to ensure pump will remain wet for improved priming capability.
Multiple Port Configurations
Pump head has two sets of suction and discharge ports for ease of installation and plumbing.
Communication Protocols
The EMP OP40 can be controlled through the following communication protocols: On-Off, J1939 CAN, PWM , EMP-Link. EMP-Link and J1939 CAN versions allow two-way communication to support diagnostics. J1939 CAN communications support J1939 messages defined for Secondary OBD Devices. PWM version provides tach-out feedback (RPM). Note: Interim solution requires use of TMC system controller.
Brushless DC Motor and Drive Controller Technology
Available with 12 VDC and 24 VDC electric motors, brushless, permanent magnet motors are combined with EMP designed motor control electronics to provide a high efficiency, long life pump. Brushless motors have no contacting parts to wear and reduce life. Features include locked rotor protection, over temperature protection, over current protection, over voltage protection and reverse battery protection.
Fully Controllable or On/Off Single Speed
EMP pumps can be run at any speed between the programmed minimum and maximum speed to minimize power consumption and noise. Variable speed can be achieved through a PWM input by varying the duty cycle of the signal. In the absence of a PWM signal the pump will run in a preprogramed default speed and operate in an on/off manner. EMP’s TMC system controller can also be used to add pressure feedback capability or control for multiple pump systems.
LEARN MORE
Enquire about the EMP OP40 Electric Oil Pump
If you would like to learn more about the capabilities of the EMP OP40 Electric Oil Pump, then please fill in the contact form below and one of the team will get back to you to answer any questions you may have.
"*" indicates required fields